Cabinet with DC-UPS J.Schneider AKKUTEC 2412C (EN54-4)

Features:

J. Schneider Elektrotechnik cabinet for DC-UPS 24V 12A


The battery buffered DC power supply is working according the stand-by parallel mode and ensures in connection with a lead-acid accumulator a safe continuous DC power supply during a determined time interval in case of mains failure. The total output current is shared between supply of the loads and charging of the batteries.

Technical Data
nominal voltage: 230 VAC (-15% / +10%)
nominal frequency: 47 Hzup to63 Hz
power consumption: 380 VA, max.
input current 1.8 A (at 12A output)
inrush current: 35 A / 2 ms, max.
Output voltage
(depending on the state of charge
of the battery voltage range)
- with temperature tracking 19,8V DC-27,8V DC
- without temperature tracking 19,8V DC-26,8V DC
nominal output current 12 A, max.
(incl. battery charging current according toVdS):
deep discharge protection and load rejection: 20,4 VDC, ± 0,4%
final charging voltage
Without temp.- sensor 26,8 V DC ± 0,4%
with Temp.- Sensor 27,1V DC ± 0,4%
at 25°
efficiency: 89%
contact load relay: 30 VDC / 0,5 A, potentialfree relay contact
type of battery: lead-acid battery, maintenancefree
environmental temperature: -5°C up to 40°C (observe life duration of battery)
storage temperature -5°C up to 50°C
dimensions (HxWxD): 608 x 464 x 213mm
weight: 12,5kg without battery
protective system housing: IP30
fuse mains: 2,5A, slow acting, 250V, switch level 1500A
fuseDC-battery circuit 15A, FK2 / FKS
fuse consumer: single max. 10A, FK2 / FKS, total max. 15A

Data sheet

POWER
150W – 300W
OUTPUT
Single
PRODUCT RANGE
Enclosed
FIELD OF APPLICATION
Industrial
Oil & Gas