Italiano
J.Schneider Elektrotechnik Battery bufferd DC-UPS AKKUTEC 2412 VdS (EN54-4)
DC-UPS J.Schneider AKKUTEC Vds
Features:
J.Schneider Elektrotechnik Battery bufferd DC-UPS AKKUTEC 2412 VdS (EN54-4)
J. Schneider Elektrotechnik battery buffered DC power supply is working according the stand-by parallel mode and ensures in connection with a lead-acid accumulator a safe continuous DC power supply during a determined time interval in case of mains failure. The total output current is shared between supply of the loads and charg-ing of the batteries.
| Technical Data | |
| Nominal input voltage | 230VAC (±15%) |
| Input voltage range for charging operation | 195.5V … 264.5V |
| Nominal frequency | 47Hz … 63Hz |
| Power consumption | 380VA |
| Self current consumption | 75mA @ 24V |
| Max. nominal input current | 1.8A |
| Max. inrush current | 35A / 2ms |
| Max. nominal output current | 12A |
| Nominal output voltage (in mains operation) | 24VDC |
| Output voltage range (with temperature tracking) | 26.4V … 28.6VDC ±0.4% |
| Charging characteristics | I/U DIN41773 |
| Charging end voltage (without Temp.-Sensor) | 26.4VDC ±0.4% |
| Deep discharge protection and load shedding | 20.4VDC ±0.4% |
| Max power loss ‚worst-case‘ | 40W |
| Efficiency | 89% @ (Ue=230V; Ua=26.4VDC; Ia=INenn) |
| Voltage ripple | < 150mV eff. |
| Internal device protection | 2.5A (T), 250V |
| Fuse DC-output circuit (external) | 15A(T) |
| Fuse DC-Battery circuit (external) | 15A(T) |
| Connection in parallel | Yes |
| Connection in series | Yes |
| Max. signal contact load (Mains-OK1 ) | 30V/ 0.5A |
| potential-free relay-contact | |
| Max. signal contact load (Bat-OK1) | 30V/ 0.5A |
| potential-free relay-contact | |
| Max. signal contact load (General Fault1) | 30V/ 0.5A |
| potentialfreier Relais-Kontakt | |
| Max. signal voltage range (Shut-Down) | 24VDC (6-45VDC) |
| floating switching input | |
| Accumulator type | Pb-accumulator, maintenance-free, max. 170Ah |
| Back-up time | Accumulator specific |
| Protective system | IP20 |
| Operating temperature | -10°C … 50°C |
| Storage temperature | -10°C … 50°C |
| Rel. Humidity | ≤95% no condensation |
| Max. installation altitude | 2000m above sea level |
| Dimensions (HxWxD) | 155mm, 95mm, 183mm |
| Weight | 1.5Kg |
| Fixation | Snap-on mountingfor DIN top hat rail |
| or mounting bracket for mounting plate | |
| Ul approvals | UL 508 |
| C22.2 |
Data sheet
- POWER
- 10W-50W
50W-100W - OUTPUT
- Single
- PRODUCT RANGE
- DIN Rail
Enclosed
Rack Mount - FIELD OF APPLICATION
- Industrial
Oil & Gas